To fit a 10 cm/4-inch tall doll
Ability Level: Experienced
This project is not suitable for a first project in miniature knitting
Materials required: one pair of UK size 19 (1.00 mm) knitting needles, 50 metres 1-ply yarn in main colour, 50 metres 1-ply yarn in contrast colour, 3 stitch holders or safety pins, 4 small buttons or beads.
Notes on materials:
1. Use cotton or acrylic yarn, as these will drape much better than wool for this design.
2. If you wish to work the design in one colour then 100 metres of yarn will be required. Ignore all references to changing yarn colours or using C, and work all pieces in a single colour.
Neck to hem – 2½-inches/6.5 cm; waist circumference – 2-inches/5cm; sleeve length – ¾-inch/2 cm; hem circumference – 12-inches/30 cm.
Tension/Gauge – this is not important as dolls vary greatly in size, check sizing given above and use as a guide.
Note: This pattern was first published in Issue 217 of The Dolls House Magazine
BEFORE PURCHASING PATTERN PLEASE NOTE:
Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.
Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.